Technics PE II

A popular unit. A number of people have this or similar including:

• John McMaster
• Markus
• Sam Z

Specifications:

• Parallel plate 15" chamber
• Microprocessor controller
• 11" electrode
• Power?
• 500 Watt @ 30Khz
  • Other source says 300W @ 13.56 MHz
• Three gas system
• Wafers
  • 4 4"
  • One 5-8"
• Weight
  • System: 120 lb
  • Module: 30 lb
  • Pump (which?): 100 lb

https://www.chiphistory.org/274-technics-pe-ii-a-planar-etcher

McMaster

Pressure gauge:

• PS/DVM
• PDR-C-1A

Previous

Summary

• Came with bad pressure gauge
  • Tried to order replacement but seller sent wrong part
  • Second replacement installed
  • Think it worked? Needs to be checked out
• Pressure gauge was likely bypassed
• Missing manifold valve
  • Replacement ordered but not installed

2020-5-06

Summary:

• Clear area around it
  • Put Ron back up
• Order lazy susan
• Vacuum gauge controller is bad
  • Modified and in bad state: repairs may be difficult
  • Looking to source identical replacement or something new entirely

Vacuum gauge

• Rewired with colored wires + better connections
• Still reading bad
  • Negative reading (switch center)
  • Low setpoint can be set (switch left)
  • High setpoint can not be set (switch right). Shows same negative value as center
• Opened gauge
  • Loose/missing cover screws
  • Several wires have been desoldered
  • Diode is hanging loose
  • Bad state. Probably not worth further troubleshooting
  • Try to source replacement identical module, or find another gauge with low/high set points